mounting of the 2-part 140cm cage on the Miniplane Classic chassis
From the bottom side drill 4mm, than rivet the hooks oriented as on the picture
remove the tank before drilling, to avoid damage if the drill bit slips
 |
to mount the 4 fittings with 6 mm internal thread, use the 12,4 mm diameter 90° countersink, |
 |
to make an housing 4mm deep |
 |
You may need to gently clean the inside thread on the frame with a 10mm tap |
 |
than use a 6Ma screw with a nut. |
 |
to screw the fitting until it locks. |
 |
To release the screw from the fitting, unscrew the nut slightly while holding the screw still, then you can remove the screw. |
